Due to a technical fault, we are currently unable to take calls. However, we are happy to receive your enquiries by email at any time.
Go to homepage
Most frequently searched
  • VetroMount
  • Glass cleaner
  • Shower door hinge Juna
  • Sliding door
  • Suction lifter
How can we help you
  • Vacuumtechnology
  • Online Shop
  • Online Shop Service
  • Case Studies VetroMount
Go to homepage
Skip image gallery

Standard diamond hollow drill

Product number: BO5000431

Description

The diamond hollow drill with an external thread (Continental) R ½ inch is made of steel covered with protective lacquer and a diamond coating of sintered material.

 

Application note:
The drill bit must be sharpened before first use! Select the correct speed Drill bit speeds: ø 3-4 mm = 4000-5000 1/min - ø 5-15 mm = 2000-3000 1/min - ø 16-25 mm = 1500-2000 1/min - ø 26-50 mm = 500-1500 1/min - ø 51-100 mm = 300-800 1/min o Speed too low: The bond between the diamond grains is not sufficiently removed, the drill bit becomes blunt and must be resharpened with a sharpening stone (BO 5000499 / BO 5000499B / BO 5000499L). o Speed too high: The diamond grains can be torn out of the bond. Ensure cooling o Diamond hollow drills require internal water cooling - external cooling is not sufficient. o For deeper drill holes, lift the drill at short intervals to flush out the drill hole. Adjust water pressure o The required water pressure depends on the drill diameter. o Without adjustment, the back pressure increases with increasing diameter and makes the feed more difficult. Reduce tool wear o The coolant Bohle Vetrocool (BO 5002827 / BO 5002828) lowers the drilling forces and reduces tool wear by up to 30 %.

Your Advantages

  • For normal use
  • Made in Italy

Technical details

Application area
Glass, Indoor, Wet
Diameter
31 mm
External thread
½ "
Length
73 mm
Model
Standard quality
Package contents
1 Piece
Revolution
500 - 1,500 U/min

Drawings

jpg
BO_5000403_z.jpg

Discover more

Skip product gallery

This might also interest you

Dressing stone for diamond hollow drill
Dressing stone for diamond hollow drill
Art. no.: BO5000498
  • Height: 13 mm
  • Length: 100 mm
  • Width: 25 mm
Sharpening stone
Sharpening stone
Art. no.: BO5000499
  • Height: 20 mm
  • Length: 90 mm
  • Width: 70 mm
Sharpening stone
Sharpening stone
Art. no.: BO5000499B
  • Height: 25 mm
  • Length: 200 mm
  • Width: 50 mm
Sharpening stone
Sharpening stone
Art. no.: BO5000499L
  • Height: 20 mm
  • Length: 180 mm
  • Width: 70 mm
Precision drill extension R ½" from 75 mm to 95 mm
Precision drill extension R ½" from 75 mm to 95 mm
Art. no.: BO5000504